Cylinder block bore ultrasonic testing device

The mechanism section consists of the drive axes: X-axis, Z-axis, R1-axis, and R2-axis! Each is driven by servo for scanning.

The "Cylinder Block Bore Ultrasonic Testing Device" is an automatic ultrasonic testing device used to inspect the cylinder block bore (the delamination of the copper and steel joint). It consists of an ultrasonic testing section, a mechanism section, and a water drainage section. Air blowing is performed at the water drainage area, with the air blowing directed from three angles: upward, sideways, and downward. The ultrasonic testing section is composed of an ultrasonic tester and a data processing computer, allowing for the setting of testing conditions, saving results, and reading them. 【Inspection Specifications】 ■ Ultrasonic testing is conducted sequentially within each bore. ■ The ultrasonic beam is reflected at a 90° angle using a mirror mechanism attached to the tip of the probe to inspect the inner surface of the bore. ■ The ultrasonic probe mechanism is rotated and moved up and down to inspect the front surface of the inner side of the bore. *For more details, please refer to the PDF document or feel free to contact us.

basic information

**Main Inspection Specifications (Partial)** ■ Equipment Size - Inspection Section: Width 1620mm × Depth 1911mm × Height 2614mm - Water Drain Section: Width 1650mm × Depth 1360mm × Height 1795mm ■ Water Tank Size - Inspection Section: Width 1300mm × Depth 770mm × Height 500mm - Water Drain Section: Width 480mm × Depth 340mm × Height 150mm ■ Ultrasonic Probe: 10MHz PF1.5 (1Ch/Frequency Range: 1MHz to 15MHz/Sensitivity: 0 to 80dB) ■ Power Source/Air Pressure: Supply Voltage AC200V 3-phase/0.4Mpa or more ■ Cycle Time: Total 375 seconds (approximately 6 minutes 15 seconds) to 305 seconds (approximately 5 minutes) *Bore Diameter: Φ33.5 to Φ17 *For more details, please refer to the PDF document or feel free to contact us.