[Case Study] Nozzle Switching

We will introduce a case where switching nozzles successfully reduced costs by approximately 15 million yen annually!

We would like to introduce a case where the "FloMax Nozzle Lance" was switched at a thermal power plant. At this location, the high frequency of nozzle maintenance was a problem, and two workers were performing the dangerous task of removing dried slurry that had accumulated on the nozzles for up to three hours every day. After the introduction, we successfully reduced costs by approximately 15 million yen annually due to a decrease in the consumption of compressor air used for injecting lime slurry. [Case Overview] ■Challenges - We wanted to reduce the use of expensive compressor air and the maintenance frequency of the spray dryer absorption system. - We were performing the dangerous task of removing dried slurry that had accumulated on the nozzles every day. *For more details, please refer to the PDF document or feel free to contact us.

basic information

**Effects** - Reduced consumption of compressor air used during the injection of lime slurry. - The 200HP compressor previously used in the system is no longer needed. - Annual cost savings of approximately 9.8 million yen. - When considering the annual maintenance cost of nozzles, which is about 6.13 million yen, a total cost reduction of approximately 15 million yen has been achieved. - Issues related to the safety of maintenance workers have been resolved. - Energy usage has also significantly decreased. *For more details, please refer to the PDF document or feel free to contact us.*