Ultrasonic Non-Contact Belt Tension Meter / Model Number M3642TT-1V

Product Inquiry

Ultrasonic Non-Contact Belt Tension Meter / Model Number M3642TT-1V

The belt tension is easily visible. A small microphone reads the belt's natural frequency and instantly displays the belt tension.

Belt tension is easily visible. Using a small microphone, it reads the natural frequency of the belt and instantly displays the belt tension. Preface To ensure that the drive belt performs at its best, it is essential to tension the belt to the appropriate level. Please use this tension gauge for managing the tension of drive belts. ● Wide range of measurable belts It can accommodate various belts such as timing belts, flat belts, V-belts, and V-ribbed belts. ● Simultaneous display of belt vibration frequency and tension value With a two-line display, you can check the frequency and tension value on the same screen. ● Wide measurement frequency range It can measure a wide frequency range from 10.0 to 999 [Hz] (upper three digits). ● Short measurement time due to unique high-speed data processing By adopting a high-performance single-chip microcontroller and unique data processing, tension measurement can be performed in a short time. (As short as 0.5 seconds) ● Equipped with memory function It can store data for 10 types of tension measurement conditions and 89 types of unit mass data.

basic information

● Equipped with an auto power-off function The power will automatically turn off after 5 minutes of inactivity. This prevents battery drain due to forgetting to turn off the power switch. ● Switchable between Japanese and English By simultaneously pressing and holding the "0" and "Enter" keys when powering on, you can switch the display between Japanese and English. ■ Measurement Method 1. Always turn off the power (switch) of the drive device and ensure that the belt is stationary. 2. Turn on the power of this device, set the microphone sensor, and input the necessary measurement conditions. 3. Fix the belt and microphone sensor facing each other at a position of about 10mm near the center of the span. 4. Lightly tap the surface of the belt with the handle of a screwdriver or similar tool to vibrate the belt. 5. Repeat steps 1 to 4 multiple times and record the average of the values read by this device.