米倉製作所 Official site

Contributed to research on changes in the internal structure of ceramics! Direct observation of changes in internal structure at high temperatures.

【Specifications】 ■ Model Number Heating Observation Image Furnace with Electronic Balance "IR-TPTG" ■ Heating Furnace Temperature Range: RT~1200℃ Heating Rate: MAX 30℃/sec Heating Method: Infrared Dual Elliptical Focusing Heating Furnace Body Cooling: Cold Water (Tap Water or Chiller) Power Supply Capacity: Single Phase 200V 10A Sample Holder: 20×20 mm Ceramic Plate ■ Electronic Balance Resolution: MIN 0.001g Maximum Weighing Capacity: 620g ■ Observation System OCT Device Microscope, etc.: Please inquire *Specifications are subject to change without notice.

It is a compactly designed high-temperature heating observation device. It can be used on your microscope or micro-scope.

【Specifications】 ○ Temperature range: +50 to 1500℃ ○ Heating characteristics: 60 seconds from room temperature to 1500℃ ○ Heating method: Infrared emission and reflection concentration heating ○ Cooling method: Natural air cooling ○ Atmosphere: In air, gas flow, or vacuum ○ Achievable vacuum level: Approximately 5Pa ○ Sample container: Outer diameter φ5×4mm, φ6.5×4mm ○ Safety measures: Furnace body temperature sensor ○ Temperature control: Digital program PID-SCR control ○ Temperature program: 16 segments, 16 patterns ○ Temperature sensor: JIS R type thermocouple ○ Power consumption: 500W/100V ● For more details, please contact us or refer to the catalog.

Minimize work inside the glove box ◎ Screening of solid electrolyte materials / Impedance evaluation by temperature characteristics ◎ Multiple uniform, short time, and accurate test evaluation

Temperature range: RT ±20~1200℃ Temperature control accuracy: ±1℃ (relative to temperature protocol) Heating speed: MAX 300℃/min Coin cell holder: 4 slots (can heat/measure under the same conditions) Structure: Heating while electrodes are attached to the top and bottom of the coin cell Coin cell diameter: Φ20~Φ8mm Heating method: Light concentration heating 【Heating test procedure】Set the sample in the holder → Seal inside the quartz tube → Take it outside as is → Just set it in the heating device.