株式会社米倉製作所 Official site

Rapid heating at approximately 50°C/sec using focused light heating method, with the possibility of rapid cooling when the heating lamp is turned off. Compatible with various atmospheres.

【Other Features】 ○ The emitted infrared radiation light is efficiently reflected and concentrated, further enhancing high heating capability. ○ With a low heat capacity heating lamp and a cooled high-reflectivity mirror, the furnace's heat capacity is minimal, allowing for rapid heating and cooling. ○ Due to its vacuum airtight structure (patent pending), direct radiation heating is possible, enabling clean and rapid heating and cooling. ○ High-temperature microscopic observation can be easily performed. 【Product Lineup】 ○ IR-HP (6 Parabolic Surface Radiation) → Rapid heating and cooling from six directions significantly expands the temperature distribution area compared to conventional heating furnaces. ○ IR-QP (4 Elliptical Shared Concentration) → Rapid heating and cooling from four directions doubles the temperature distribution area and rapid heating compared to conventional heating furnaces. ○ IR-TP (2 Elliptical Shared) → Rapid heating and cooling from two directions enables microscopic observation compared to conventional heating furnaces. ● For more details, please contact us or refer to the catalog.

Contributed to research on changes in the internal structure of ceramics! Direct observation of changes in internal structure at high temperatures.

【Specifications】 ■ Model Number Heating Observation Image Furnace with Electronic Balance "IR-TPTG" ■ Heating Furnace Temperature Range: RT~1200℃ Heating Rate: MAX 30℃/sec Heating Method: Infrared Dual Elliptical Focusing Heating Furnace Body Cooling: Cold Water (Tap Water or Chiller) Power Supply Capacity: Single Phase 200V 10A Sample Holder: 20×20 mm Ceramic Plate ■ Electronic Balance Resolution: MIN 0.001g Maximum Weighing Capacity: 620g ■ Observation System OCT Device Microscope, etc.: Please inquire *Specifications are subject to change without notice.

It is a compactly designed high-temperature heating observation device. It can be used on your microscope or micro-scope.

【Specifications】 ○ Temperature range: +50 to 1500℃ ○ Heating characteristics: 60 seconds from room temperature to 1500℃ ○ Heating method: Infrared emission and reflection concentration heating ○ Cooling method: Natural air cooling ○ Atmosphere: In air, gas flow, or vacuum ○ Achievable vacuum level: Approximately 5Pa ○ Sample container: Outer diameter φ5×4mm, φ6.5×4mm ○ Safety measures: Furnace body temperature sensor ○ Temperature control: Digital program PID-SCR control ○ Temperature program: 16 segments, 16 patterns ○ Temperature sensor: JIS R type thermocouple ○ Power consumption: 500W/100V ● For more details, please contact us or refer to the catalog.

Minimize work inside the glove box ◎ Screening of solid electrolyte materials / Impedance evaluation by temperature characteristics ◎ Multiple uniform, short time, and accurate test evaluation

Temperature range: RT ±20~1200℃ Temperature control accuracy: ±1℃ (relative to temperature protocol) Heating speed: MAX 300℃/min Coin cell holder: 4 slots (can heat/measure under the same conditions) Structure: Heating while electrodes are attached to the top and bottom of the coin cell Coin cell diameter: Φ20~Φ8mm Heating method: Light concentration heating 【Heating test procedure】Set the sample in the holder → Seal inside the quartz tube → Take it outside as is → Just set it in the heating device.