ティックコーポレーション 本社 Official site

Blow away water, dust, and dirt from parts with high-speed air and dry quickly. Demo units are also available for loan!

A system that efficiently and economically performs water removal and drying after product cleaning, as well as blowing away chips and dust after product molding, by blowing out high-speed air with low noise and large air volume from an air knife. ◆Product Features◆ - Saves power consumption to a fraction of that used in similar operations with conventional compressed air (reducing CO2 emissions). - Compact and space-saving, making it ideal for installation alongside existing equipment with space limitations. ≪Sonic Rotary Air Knife (patented)≫ Even with uneven surfaces, high-speed air can reach all parts, effectively drying them. ≪Sonic Sanitary Air Knife≫ Designed for direct blowing on food, meets the 3A sanitary standards. Can be quickly disassembled for regular cleaning and sanitation. ≪Sonic XE Air Knife≫ Compatible with a wide variety of specifications in factories. Available in two types: aluminum with hard anodized coating and stainless steel.

Seeing is believing! Improve drying and reduce running costs by using a high-speed air knife to blow off air discharged from a high-volume blower!

A job that required a pressure of 0.4 MPa has been achieved with just 29 kPa! When comparing the airflow of a compressor and a sonic blower, 62.5 horsepower is needed to obtain an airflow of 7 m³/min with a compressor. In contrast, the sonic blower can achieve this with only 4 horsepower. The difference is significant compared to compressors and domestic blowers!

"Sonic" water drainage drying is Sonic!! We are introducing case studies, conceptual installation diagrams, and photos.

【Contents】 ○ Success Stories → Labeling Issues → Steel Industry [Removal of Residuals on Plates] → Drying of Automotive Cylinders → Propane Gas Cylinders Not Fully Dried → Contamination of Particles Due to Static Electricity in Clean Rooms → Removal of Residual Water After Cleaning Contact Lens Pallets ○ Concept Installation Diagram ○ Photos ● For more details, please contact us or refer to the catalog.

"Sonic" drying is Sonic! We are introducing success stories and photos. [Simplified version]

【Publication Content】 ○Success Stories →Labeling Issues →Steel Industry [Removal of Residues on Plates] →Drying of Automotive Cylinders →Propane Gas Cylinders Not Fully Dried →Removal of Residual Water After Cleaning Contact Lens Pallets ○Photos ●For more details, please contact us or refer to the catalog.

Non-contact water removal and drying of wire cables using Sonic Corporation's blower and air knife.

【Application Success Case】 ○Problem → Due to a rapid increase in line speed, the conventional method became costly and inefficient. → If the cable is not completely dried, the inspection machine misidentifies it and judges it as a defective product. ○Solution → Due to the high-speed production of 3000 feet/min (900m/min), Sonic recommended the SP dryer. → This is a drying device housed in a box featuring air knife technology (XE 42” long) that achieves energy savings with a centrifugal blower (Sonic 150, 20 horsepower). ○Conclusion and Benefits → There was no downtime during installation. Installation, setup, trial operation, and verification took only one day. → The additional installation of a new spark tester was no longer an issue. → Not only did they improve their quality, but they were also able to increase production speed through enhanced drying efficiency. ● For more details, please contact us or refer to the catalog.