General installation example for 2400 hopper

Introducing a general example of the installation of the bridge breaker "Brodisk"!

This is an introduction to the general case of installing the bridge breaker "Brodisk." The pressure of the air slightly lifts the perimeter of the elastic disk, allowing powerful air to be ejected 360° along the tank wall. At the same time, the elastic disk vibrates, directly imparting vibrations to the bulk material. This combined effect of "wall air aeration" and "vibration" resolves bulk material issues. For more details, please contact us or download the catalog. 【Key Points of This Equipment】 ■ The elastic disk (silicone) is very important in terms of strength and durability due to the risk of foreign material contamination. Our silicone disk has excellent strength and durability. Once you use it, you will understand! ■ Control (how to aerate?) is crucial! We provide guidance on what to do. A dedicated controller is also available.

basic information

【Installation General Examples】 ○ Generally, the BD-15 type (standard) with the least amount of air is used. ○ The installation position is typically set 300 mm above the hopper wall along the discharge section at the lowest point. The upper section is installed an additional 450 mm to 600 mm higher. ○ In this case, since the lower section is installed 450 mm above the discharge section, it is also possible to lower two of the four lower units slightly (by 200 mm to 250 mm). ○ When installing multiple blow disks, air is turned ON/OFF in sequence at several locations. In this case, the order is from the lower to the upper. ○ In this case, the controller (timer panel) controls three external solenoid valves to sequentially aerate 12 blow disks divided into three locations. ○ For more details, please feel free to consult us. If you provide the hopper diagram and type of powder, we will suggest the optimal position. ● For more details, please contact us or download the catalog.