General installation example for a 1000 hopper.

This is an introduction to general examples of installing the bridge breaker "Brodisk"!

This is an introduction to general examples of installing the bridge breaker "Brodisk." The pressure of the air slightly lifts the perimeter of the elastic disk, allowing powerful air to be ejected 360° along the tank's wall. At the same time, the elastic disk vibrates, directly imparting vibrations to the bulk material. This combined effect of "wall air aeration" and "vibration" resolves bulk material issues. For more details, please contact us or download the catalog. 【Key Points of This Equipment】 ■ The elastic disk (silicone) is very important in terms of strength and durability, especially considering the risk of foreign material contamination. Our silicone disk is exceptionally strong and durable. Once you use it, you will understand! ■ Control (how to aerate?) is crucial! We provide guidance on what should be done. We also have a dedicated controller available.

basic information

【General Installation Examples】 ○ Generally, the BD-15 type (standard) with the least air volume is used. ○ The installation position is typically set 300 mm above the hopper wall along the discharge section. ○ In this case, the units are installed at the center of each side, but for corner hoppers, it is also effective to position them closer to the corners, as material tends to accumulate in those areas. ○ Additionally, in this case, a controller with four built-in solenoid valves sequentially turns the air ON/OFF for the four blow discs. ○ For powders with poor fluidity or when the discharge outlet diameter is small, it is more effective to aerate sequentially rather than turning all blow discs ON/OFF simultaneously. ○ For more details, please feel free to consult us. If you provide us with a hopper diagram and powder type, we can suggest the optimal positions. ● For more details, please contact us or download the catalog.