0087 Powder filling equipment Preventing bridging in mobile raw material hoppers

0087 Powder filling equipment Preventing bridging in mobile raw material hoppers

Hopper for powder filling equipment and auxiliary equipment. Measures have been implemented to address bridging in a mobile small raw material hopper equipped with casters.

Initially, in preparation for the bridge at the discharge section, two Bro-Disk Minis with a diameter of 50 mm were installed at the upper part of the discharge section (the area where the bridge was anticipated). However, when it actually operated, even though there was no clogging in that area, it became a rat hole state with holes only in that part, which led to your consultation. As a result of our consultation, since it was very fine powder and adhesion was also anticipated, we installed a slightly larger number of units as follows. ... Bro-Disk is an inexpensive device. Even if you install many of them, the cost-effectiveness is sufficient! Of course, it has started to operate well. Even if you have experience in bridge countermeasures, if you have any concerns or worries, please feel free to contact us. We believe we have many experiences we can share with you. This time, we submitted the mill sheet for the shaft part and the food sanitation law compliance certificate for the elastic disk. If you need these documents, we can prepare them immediately, so please feel free to request them. If you are struggling with powder and granular materials, please consult our company. We have published many implementation examples on our website. You can check them from the link below.

basic information

【Hopper Shape】 Conical 【Upper Straight Cylinder Diameter】 Approximately 550φ 【Discharge Diameter】 Approximately 50φ 【Material Name】 Unknown, quite fine powder 【Installation Position】 Four units 150mm above the discharge section along the hopper wall, and another four units 150mm above that, totaling eight units. The four units in the lower section and the four units in the upper section are positioned at a 45-degree rotation when viewed from above. 【Key Points of This Equipment】 ■ The elastic disk (silicone) is very important in terms of the risk of foreign material contamination, so strength and durability are crucial. The silicone disk of this equipment is extremely excellent in strength and durability. You will understand once you use it! ■ Control (how to aerate?) is important! We provide guidance on what should be done. A dedicated controller is also available. *For more details, please feel free to contact us by phone. TEL: 06-6777-2777