0397 Prevention of bridge formation of dust containing glass fibers

Prevention of dust containing glass fibers! An example of applying a blow disk to the hopper section of a dust collector.

This is a case where a blow disk was adopted for application to new equipment. The application location is the dust collector hopper section. Since the blow disk injects air along the inner surface of the hopper, it is generally the case that the effectiveness does not change significantly even if the installation position is slightly off. The key point this time is that due to the properties of the target material, the air pressure used is high, the air ON time is short, and air aeration is performed in a pulsed manner. [Overview] ■ Hopper approximate dimensions: 2000×2000 (discharge section 200×200) ■ Blow disk arrangement - 3 units per 4 sides, with 1 unit on the lower level and 2 units on the upper level per side (However, only 2 units are installed on one side due to the inspection port) - Both lower and upper levels are positioned quite low, near the discharge port * For more details, please refer to the PDF document or feel free to contact us. * Our website features numerous implementation examples. You can check them from the link below.

basic information

【Product Specifications】 ■ Broady Disk: BD-15S-B, 11 pieces 【Key Points of This Device】 ■ The elastic disk (silicone) is very important in terms of strength and durability, especially considering the risk of foreign material contamination. The silicone disk of this device is exceptionally strong and durable. Once you use it, you will understand! ■ Control (how to aerate?) is important! We provide guidance on what should be done. A dedicated controller is also available. *For more details, please refer to the PDF document or feel free to contact us. TEL: 06-6777-2777